Victron Energy MultiPlus-II 48V 3000VA 35-32 230V GX

The MultiPlus-II GX is the combination of a MultiPlus-II inverter/charger and a GX device. It has a 2 x 16 character display, on which you can read inverter, battery and solar charge controller parameters (also accessible via smartphone).

Inverter/Charger with GX inside

An inverter / charger with built-in device networking, the Victron MultiPlus-II GX communicates with many batteries (such as Pylontech batteries), solar chargers and other devices to control a grid-connected, off-grid or remote power installation.

Here is the list of compatible batteries.

The device is capable of parallel operation for increased power output or battery charge-rates. The Victron Energy MultiPlus-II GX can also be configured for three-phase supply. Only one GX unit is needed for this.

Lots of features can be controlled from your smartphone:

• uninterrupted power supply
• setting load limits
• supplementing limited grid-power availability with battery power
• remote monitoring

Applications

The Victron MultiPlus-II 48V 3000VA 35-32 230V GX is suited for applications where additional interfacing with other products and/or remote monitoring is necessary, like on-grid or off-grid energy storage systems (ESS) and some mobile applications.

The device can be connected to up to two PV inverters. The power of an inverter should not exceed 3kW to maintain balance.

The Victron Energy MultiPlus-II uses excess DC power to charge batteries or to feed back power into the grid. Conversely, it can also discharge the battery and use the power from the grid to compensate for a shortage of DC power.

Another important advantage: The MultiPlus can also form a three-phase network, be connected to other MPII devices and generate a lot of power together.

In the event of a power outage, the device will disconnect the grid and continue to supply the loads. Switching is so fast that electronic devices continue to operate without interruption.

GX functionality

The GX-device is the communication-centre that monitors the installation, provides firmware updates and allows to change the MultiPlus settings remotely.

The integrated GX device includes:

• VE.Can interface to connect to Victron VE.Can devices (eg VE.Can MPPTs) (can also be reconfigured via Remote Console for use with compatible CAN-bus Li-ion Battery)
• VE.Direct port
• Ethernet port
• USB port

Downloads - Victron MultiPlus-II GX Inverter / Charger

Datasheet (PDF, 653 KB)

Search words: MultiPlus II, MultiplusII, Multi II, Multi Plus 2, MultiPlus 2, Multi 2, Multi, MP2, MP 2, MP